11/04       CPU test GKAA

ABSTRACT :
This test WRITES "END OF DGKAA" after one pass.
It checks all of the processor logic and microcode for all basic 11/04 instructions except the TRAP instructions. The test does not check RTT, RTI, WAIT, RESET, TRAP, EMT instructions.

To test the full 11/04 run after GKABC0.BIC.

To give you an idea what is tested :

. all branches on the condition codes
. tests internal data path (UNIBUS data transceivers
  and AMUX with different data patterns
. tests all scratch pad registers (GPR's)
. tests the PSW, write into and read it back
. tests the B-register shifting logic
. tests setting and clearing of the condition codes
. tests all possible address modes
. tests all instructions specified above
. tests every possible microcode flow

OPERATING PROCEDURES :
200   normal start

SWITCH SETTINGS :
None.

NOTES :
None.

close this window