- Set the ENABLE/HALT switch to the HALT position.
- Set the first address (often 001000) in the switch register.
- Press the LOAD ADDR switch.
- Set the contents of the first address (from the table below)
in the switch register.
- Lift the DEP switch.
The computer automatically advances to the next address.
- Set the contents for the next address (from the table below)
in the switch register.
- Lift the DEP switch.
- Repeat the last two steps until you have deposited all the instructions.
How to verify the deposited bootstrap loader program.
- Set the first address (001000) in the switch register.
- Press the LOAD ADDR switch.
- Press the EXAM switch to display the contents of that address
in the DATA register.
- Compare the value in the DATA register with the value from
the table below.
- If the values are the same press EXAM again to display the contents of the next address.
If the values are not the same repeat the steps of the bootstrap load description.
How to start the bootstrap program (the computer).
- Set the start address (001000) in the switch register.
- Press the LOAD ADDR switch.
- Set the ENABLE/HALT switch to ENABLE.
- Press the START switch.
   
close this window